Quick start
Floor Lite

• Remove the mounting screw, PET washer, and steel washer from the light pole using the supplied hex key SW3.
• Attach the light base to the light pole and tighten it with the hex key SW3.
• Place the preassembled light onto the light base and remove the protective sleeve.
• Slide the swivel arm onto the connector of the light pole and rotate it 90 degrees to the horizontal position.
• Hold the swivel arm in place and tighten the two set screws with the hex key SW2. Use the ball end of the hex key at a slight angle to avoid collisions.

The lamp is controlled by gestures. The sensor that recognizes gestures is located in the lamp head. Gestures are detected within a range of 5 cm to 30 cm below the lamp head.
There are three directions for the gestures:

•     Move your hand straight toward the lamp post through the detection field, in the direction of the LUCTRA logo.
•     Move your hand through the detection field from right to left or left to right.
•     Move your hand within the detection field upward toward the lamp head or downward toward the table surface.

ON/OFF:
HAND MOVEMENT TOWARDS THE LAMP HEAD
To turn the lamp on or off, move your hand in a smooth motion from the front into the sensor's detection field and then back towards the lamp stem.

DIMMING:
HAND MOVEMENT UP OR DOWN

To decrease the brightness, hold your palm still at medium height in the sensor's detection area for one second and then slowly move it from bottom to top. Keep your hand in the detection area until the brightness decreases.

To increase the brightness, hold your palm still at medium height in the sensor's detection area for one second and then slowly move it from top to bottom. Keep your hand in the detection area until the brightness increases.